
Commercial Heating Installation
in North Texas
New commercial heating installation and system replacement throughout North Texas — properly sized, code-compliant, and built for the demands of commercial facilities. RTU heat sections, commercial furnaces, and heat pumps. Crane-assisted lifts included.
Commercial heating installation — from sizing through commissioning
Most commercial heating in North Texas is delivered through rooftop package units with gas heat sections — the same RTUs that handle cooling in summer switch to heating mode when temperatures drop. When one of those units reaches end of life or fails beyond economic repair, the replacement involves crane equipment, proper sizing, electrical hookups, gas connections, and full system verification. Rock Hard handles the complete process.
We also install dedicated commercial furnaces for facilities that require a separate heating system, and commercial heat pumps for operations seeking year-round efficiency. Every installation is sized correctly for your facility — not matched to the old unit's tonnage, which may have been wrong to begin with.
Oversized commercial heating systems short-cycle — they heat a space quickly but never run long enough to warm it evenly or run efficiently. Undersized systems run continuously without reaching setpoint during hard freezes. We perform load calculations based on your actual facility before recommending any equipment.
What's included in a commercial heating installation



Heating installation for commercial build-outs and renovations
For commercial build-outs, tenant improvements, and facility expansions, we integrate the heating scope with your broader construction timeline. We coordinate with general contractors and other trades, route ductwork and gas lines that don't conflict with refrigeration systems, and deliver a complete installation ready for certificate of occupancy inspection.
The installation determines the system's performance ceiling for its entire lifespan
A commercial heating system installed with accurate load calculations, correct gas pressure, and proper heat exchanger clearances will run efficiently and reliably for 15–20 years. One that's oversized, undersized, or improperly connected will cost more to run, fail more frequently, and need replacement years before its rated lifespan.
Rock Hard doesn't cut corners on sizing or connections because we're the ones who will be maintaining these systems afterward. We have a direct stake in getting the installation right.




Serving North Texas businesses
Based in Aubrey, TX — commercial heating service across Denton and Collin Counties and the greater DFW metro.
Commercial heating — answered
Request a commercial heating installation estimate
Tell us your facility type, heating requirement, and North Texas location. We will provide a detailed installation estimate.